سلام

من تو قسمت اپلود کردن مشکل دارم


Arduino: 1.6.8 (Windows 10), Board: "Arduino/Genuino Mega or Mega 2560, ATmega1280"

In file included from sketch\Repetier.h:597:0,

from C:\Users\amir\Desktop\Repetier-Firmware-master\src\ArduinoAVR\Repetier\Repetier.ino:184:

sketch\HAL.h:80:0: warning: "SERIAL_RX_BUFFER_SIZE" redefined [enabled by default]

#define SERIAL_RX_BUFFER_SIZE 128

^

In file included from C:\Program Files (x86)\Arduino\hardware\arduino\avr\cores\arduino/Arduino.h:224:0,

from sketch\Repetier.ino.cpp:1:

C:\Program Files (x86)\Arduino\hardware\arduino\avr\cores\arduino/HardwareSerial.h:53:0: note: this is the location of the previous definition

#define SERIAL_RX_BUFFER_SIZE 64

^


Sketch uses 96,250 bytes (75%) of program storage space. Maximum is 126,976 bytes.
Global variables use 3,386 bytes (41%) of dynamic memory, leaving 4,806 bytes for local variables. Maximum is 8,192 bytes.
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0xf4
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0xf4
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0xf4
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0xf4
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0xf4
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0xf4
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0xf4
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0xf4
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0xf4
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0xf4
Problem uploading to board. See http://www.arduino.cc/en/Guide/Troubleshooting#upload for suggestions.

This report would have more information with
"Show verbose output during compilation"
option enabled in File -> Preferences.


برنامه مارلین هم لینک شما هم از سایت برداشتم نشد